新聞banner
Your current location : Home >> News >> Technical information

Reasons for no rivet joint wear

2019-10-21

Reasons for rivet-free connection to wear equipment


    1. The belt runs off. The roller rubber wear and the idler roller work are not normal, which affects the belt deviation. The roller at the high point of the belt offset is very strong, and the long-time working roller is simply worn and thinned until cracking.


2. The ash residue adheres to the belt return section. The wiper blade is worn, does not stick to the belt surface, the ash viscosity increases, and the water content is high, which will constitute the belt surface with slag.


3. The ash has a high moisture content. The filter slag bin water filter element and the hydrophobic pipe are blocked, the sluice drain pipe is blocked, and the water filter component is not flushed in time after slag discharge, which will cause the ash to carry too much water.


4. The buffer slag bin ash is straight. The ash from the slag machine is not dehydrated at the time of punctuality, and is directly transported to the dewatering tank by the tubular belt conveyor, which will constitute more ash and water, and the tube belt conveyor will increase the idle time and accelerate the wear of the roller.


  5, no rivet joint bearing quality. Some roller work surface cleaning, due to bearing quality problems will also constitute a change in insensitivity or jam, and then wear.


6. The sealing function without rivet connection is poor. The slag is collected into the idler bearing, which constitutes a jam or a poor conversion sensitivity and constitutes wear.


7. Wear of the slurry ash to the roller. Sometimes the slurry ash from the slag machine is simply attached to the tape and dropped onto the bracket and the roller shaft at both ends of the roller. On the one hand, the roller body is worn out, and on the other hand, it is agglomerated to form a cassette.


8. Wear of the ash residue with a large particle size on the roller body. Sometimes the larger ash from the slag machine sticks to the tape, and the hard and sharp material wears quickly on the roller body.


9. The ash residue at the mouth of the tubular belt overflows. The idler roller of the roller set wears out, and the belt conveys too much material, which will constitute a belt bag not tight, and the belt will have a certain resonance. The ash overflow at the mouth of the bag will cause the other rollers to wear faster.


Recently Viewed:

Tel: 13776173322 Fax: 53105101


Address: N0.88Kuntai Road(Tianggong Industrial Park)Taicang City Jiangsu P.R. China


Copyright ? SuZhou Simitch Machinery CO.,LTD Specializing in ,Welcome to inquire!
汽車零部件鉚接專機  汽車零部件鉚接專機

Mobile station

WeChat

Contact

TEL:0512-53105098

Message
{转码词1},{转码词2},{转码词3} 直接看的av种子网站| 校园春色性爱| Se影院| 日本av电影图| 影音先锋日本色资源网| www,kkk400cog| 2018最新黄色网址| 色中色com.1997| 先锋影音av资源| 小说乱伦| 日本女优av片子| 亚洲色情图| av亚洲影院| Av天堂影音先锋手机在线观| 宜家xfplay| 操逼大作战| 影音先峰在线| 欧美幼女裸体性爱大全| 色中色最新电影图片| 亚州日韩女优| 最牛A片|